Brightly lit dust, electromagnetic pulse valve instructions provided by the brightly lit electromagnetic pulse valve dust. We are Botou brightly lit dust Equipment Co. (www.tmccsb.com) located at: Hebei Cangzhou specializes in: bag filters, electrostatic precipitators, bag filter accessories, electrostatic precipitator parts [Technical requirements: 1, product working pressure of 0.1MPa ~ 0.7MPa electromagnetic pulse valve manufacturers, through the medium of oil, in addition to air-water treatment. 2, under the product nominal supply pressure state, the solenoid valve operating voltage is 85% of the rated voltage, open electromagnetic pulse valve response time should be less than 0.03s. 3, the working gas supply pressure is 0.1MPa electromagnetic pulse valve hot, you can make the pulse valve closed. 4, the product should be able to withstand the gas supply pressure 0.8MPa. 5, under specified environmental conditions, electromagnetic coil housing insulation resistance should be greater than 1MΩ. 6, at room temperature 5 degrees to 35 degrees, relative humidity less than 85% under the conditions described electromagnetic pulse valve, solenoid coil casing can withstand voltage 50Hz, 250V, which lasted 1min without breakdown. 7, electromagnetic pulse valve to withstand the frequency of 20Hz, the full amplitude of 2mm, which lasted 30min after vibration should be able to work properly. 8, under normal conditions of use, cumulative patch should be more than 800,000 times the service life. 9, no significant valve exterior coating peeling, scratches, burrs and other damage. Submerged electromagnetic pulse valve Technical Specifications: Working pressure: 0 3-0 6Mpa medium: clean air voltage: Dc24v / Ac220v Current: 800mA / 60mA Operating environment: temperature a 10 ℃ ~ 55 ℃ Relative air temperature does not exceed 85% of the diaphragm Life: 1 million times or 2 to 3 years